Your cart is empty.

E120IR: HDMI Matrix Extender Over IP By CAT 5E/6 Cable With IR control Full HD 1080P

  • Model: E120IR




Product Detail

Introduction

This is a device based on the standard TCP/IP protocol for transmitting HD audio and video source over LAN . It transmits your HD display with the high resolutions up to 120 meters away from your HDMI or DVI-D source by using one CAT5e/6 cable. At the same time, it’s also convenient to transmit HDMI audio and video source by point-to-point, multipoint-to-multipoint and cascade connection mode.
 

HDTV REsolution

480p,720p,1080p

Audio

Sample rate:32kHz,44.1kHz,48kHz

IR remote control

38kHz;NEC

HDMI

HDMI 1.3

HDCP

HDCP 1.2

Power adapter

DC5V/1A

Power consumption

HDMI Sender:3W    HDMI receiver:3W

Size(L-W-H)

92x79x28mm

Weight

240g x 2

Operating Temperature/Humidity

0℃-70℃/10%-80%RH(no condensation)

Storage Temperature/Humidity

-10℃-80℃/5%-90%RH(no condensation)

 
 

Interface Diagram:
HDMI Transmitter

 

Port Function
DC/5V Supply power for the transmitter
RESET Hold down the key,the model will re-start
IR-TX Connect IR transmitter to this port
HDMI IN Connect HDMI source to this port
UTP OUT Cat5e/6  cable out
SET Multipoint to multipoint match setting

HDMI Receiver

 

 

Port Function
DC/5V Supply power for the receiver
RESET Hold down the key,the model will re-start
IR-RX Connect IR receiver to this port
HDMI OUT Connect HDTV to this port
UTP IN Cat5e/6  cable in
SET Multipoint to multipoint match setting

 

Connection and operation

1) Connect the HDMI source to the HDMI Transmitter with HDMI cable

2) Connect the HDMI receiver to the HDTV display with HDMI cable.

3) Use one Cat5e/6 cable up to 120m to connect the Sender and Receiver.

4) Connect the “IR receiver “into “IR-TX” port on transmitter, and “IR transmitter ” into the “IR-RX” on receiver, and make sure the IR transmitter aim at IR receiver of the controlled device if you need the IR control function.

5) Connect two pieces of 5V power supply to the transmitter and receiver, power supply for the equipment and the LED indicator light on. When status lamp on and flicker, equipment starts normal.

 

Application Diagram

 
 

Package Content

1) one piece of HDMI transmitter

2) one piece of HDMI receiver

3) Two pieces of DC 5V power supply

4) One pair of IR transmitter and receiver

5) User’s Manual